P.O. Box 75986, Manurewa, Auckland     New Zealand
PH: 64 9 269 0710  FAX: 64 9269 4140
Email: info@pacificurethanes.co.nz

ABOUT US          PRODUCT RANGE     RESPONSE FORM  

2 COMPONENT FOAM KITS   USER GUIDE

Technical data

Product How to's

Trouble shooting

Two-Component Foam Kits Use Guidelines ALWAYS review and follow the directions provided in your foam kit.  The below instructions are a general overview, meant to accompany the reference photos.  ENSURE you follow all safety precautions including wearing protective eyewear and gloves. Prepare the Area Make sure area to receive foam is clean and dry. Ensure the area has adequate ventilation.  If flow-through ventilation isn’t possible, wear respiratory gear and ensure you can exit the area quickly if fumes become overwhelming. Ensure appropriate ambient temperature.  Check application temperature in the instructions. Set-up the Foam System Rock the box or tanks to agitate the product thoroughly.   Ensure foam is brought to a temperature between 20-32°c before dispensing.  Failure to ensure proper temperature may affect product performance.   Tear open the top of box along perforated lines (Figure 1).   Remove instructions and accessories bag (Figure 2).   Make sure gun is “OFF” by pushing trigger lock into gun body.   Attach hoses.  Connect the red hose to the red cylinder (unit A), connect the white hose to the white tank (unit B), inserting hoses into carton holes.  Tighten hoses with wrench provided.   Close cartons, unlock gun and spray into waste container to ensure chemicals distribute evenly and equally from both hoses.   Lubricate o-ring (petroleum jelly is fine).   Select spray nozzle (yellow for fan pattern/flat areas, transparent for high-velocity linear spray/cracks and voids).  Align slots on nozzle with notch on gun barrel and push/twist nozzle clockwise to lock in place (Figure 3).   Spray again into waste container to ensure product is mixing properly.  The foam should be off-white in color (not brown or white – which indicates one unit is not working properly) ( Figure 4). Call our customer service group at 800-325-6180 if you believe your foam kit isn't spraying properly.   Foam is now ready to apply.	Figure 1
	Figure 2
	Figure 3
	Figure 4

STORAGE REMINDERS
Materials may be stored below 20°c. However, temperatures of A & B canister materials must be brought to a minimum of 20°c prior to application. Canisters stored in low temperatures may require more than 24 hours to warm their chemical contents.

APPLICATION REMINDERS
For optimum performance and foam quality, the temperature of the spray environment and foam materials should be 20-25 °c. Application in temperatures below 20°c may increase set up time and reduce overall performance of polyurethane foam.

WARRANTY AGAINST PRODUCT PERFORMANCE/FAILURE
Please read carefully and adhere strictly to the operating instructions, warnings and cautions contained in or affixed to this product. Failure to follow all instructions, directions, warnings, and cautions shall release Convenience Products from any and all liability. Representatives, distributors and dealers of this product may make no claims or warranties not herein expressed.